ATLANTA: SERVO WORM GEAR BOXES

Outside racks and pinions Atlanta also produces servo driving elements. The high precision servo worm-worm gear boxes, up to 1 arcmin, are ideally suited for applications where large axial forces occur due to the helical teeth.

FEATURES

Worm-Worm gear with a gear ratio (i) of 4.75 to 50.
Different designs with different mounting options available.
Backlashes from <6 to <1 arcmin, in no-load condition.
Sizes for a axle spacing of 32 to 100 mm.
Different motor adapters and couplings are available separately.
The servo worm-worm gear reducer units are ideal for applications where large axial forces occur due to the bevel gear.

HT HIGH-TORQUE REDUCTION BOX

150% torque on output shaft.
Backlash <1 arcmin, in no-load condition.
Mounting options of a gear: Bolt or clamp connection.
Gear ratios (i): 4.75/6.75/9.25/14.50/19.50/29.00/39.00/50.00
4 different sizes. 50-63-80-100 mm axle spacing.

HP HIGH-PERFORMANCE REDUCTION BOX

Direct link to output shaft
Backlash <2 arcmin, in no-load condition.
Mounting options of a gear: Spline or clamp connection
Gear ratios (i): 4.75/6.75/9.25/14.50/19.50/29.00/39.00/50.00
5 different sizes. 50-63-80-100-125 mm axle spacing.

E ECONOMY REDUCTION BOX

Direct link to output shaft
Backlash <2 arcmin, in no-load condition.
Mounting options of a gear: Spline or clamp connection
Gear ratios (i): 4.75/6.75/9.25/14.50/19.50/29.00/39.00/50.00
5 different sizes. 50-63-80-100-125 mm axle spacing.

GEARS WITH A SPLINED CONNECTION

The gear and the shaft form one whole. This is mounted in the reduction box with a splined connection. You can choose from straight and bevel toothed gears.

SPECIAL SHAFTS

These shafts are equipped with splines so any gear can be mounted on them. These shafts can be mounted in the reduction box using a splined connection or a clamped connection.

GEARS WITH A CLAMP CONNECTION

The gear and the shaft form one whole. This is mounted in the reduction box with a clamp connection. You can choose from straight and bevel toothed gears.